1 x Kitchen Towel Rack
4 x Large Adhesive Strips
1 x Adhesive Cleaning Sheet
Allows you to place most kitchen towel rolls for easier tear and dispensing
High-strength adhesive works great on a variety of surfaces – tile, fiberglass, painted surfaces, finished wood, mirrors and more
Slowly pull the tab straight down for damage-free removal from surface
One bar holds 1KG
To apply kitchen towel rack:
1. Clean & Dry Surface
Step A: Clean, wipe wall and dry.
Step B: Tear adhesive cleaning foil along the dotted line. Avoid hand contact with sheet.
Step C: Apply the adhesive cleaning sheet to the intended position of the strip in a downward direction and let it stand for 5 minutes. Make sure the wall is dry before proceeding to step 2.
*Note: Do not remove sheet from foil and avoid hand contact with cleaning sheet. Rinse with water immediately if in contact with skin.
2. Seperate & Apply strip
Two strips will go on each mounting base. Seperate strips. Remove red Command strip liner. Align square end of strip with solid line on top of mounting base. Placing one strip on each side of the dotted lines. Remove black “wall side” liners.
3. Position & Press Firmly
Position rack horizontally and press the entire rack firmly against surface for 30 seconds.
Caution: Place rack in accessible position for removal by ensuring tab can stretch at least 20cm downwards upon removal
4. For optimal holding strength
Remove rack by sliding it upwards to remove from mounting bases. Remove gently to avoid scratching the surfaces.
5. Press firmly
Use your palm to firmly press each of the mounting bases along the length of the strip for at least 30 seconds.
Note: If mounting in moist areas, especially on ceramic tile or glass, wait 24 hours to allow adhesive to bond before use.
6. Attach rack
Slide rack back onto mounting bases, pushing it all the way down until it snaps into place.
1. Slide rack r off bases
Hold rack lightly as shown and slide upwards to remove rack from bases
2. Remove strip
To prevent mounting base from snapping your fingers, hold the base lighly as shown, DO NOT press against base against wall. SLOWLY slide tab STRAIGHT DOWN AGAINST THE WALL stretching strip at least 20cm until mounting bases releases from the wall.
Note: NEVER pull strip out at an angle. Strip could break or damage surface.