3M Command Stainless Steel Sponge Holder 17679B
Includes: 1 x Sponge Holder 1x Large Adhesive Strip 1 x Adhesive Cleaning Sheet
Description:
To hold sponge One bar holds 1KG Large water resistant strips which allow for usage on wet surfaces included
To apply Sponge holder: 1. Clean & Dry Surface Step A: Clean, wipe wall and dry. Step B: Tear adhesive cleaning foil along the dotted line. Avoid hand contact with sheet. Step C: Apply the adhesive cleaning sheet to the intended position of the strip in a downward direction and let it stand for 5 minutes. Make sure the wall is dry before proceeding to step 2. *Note: Do not remove sheet from foil and avoid hand contact with cleaning sheet. Rinse with water immediately if in contact with skin. 2. Seperate & Apply strip One strip will go on the mounting base. Remove red Command strip liner. Align square end of strip with solid line on top of mounting base. Remove black "wall side" liner. 3. Position & Press Firmly Position holder horizontally and press the entire holder firmly against surface for 30 seconds. Caution: Place holder in accessible position for removal by ensuring tab can stretch at least 20cm downwards upon removal 4. For optimal holding strength Remove holder by sliding it upwards to remove from mounting bases. Remove gently to avoid scratching the surfaces. 5. Press firmly Use your palm to firmly press each of the mounting bases along the length of the strip for at least 30 seconds. Note: If mounting in moist areas, especially on ceramic tile or glass, wait 24 hours to allow adhesive to bond before use. 6. Attach holder Slide holder back onto mounting bases, pushing it all the way down until it snaps into place. To remove: 1. Slide holder off bases Hold holder lightly as shown and slide upwards to remove holder from bases 2. Remove strip To prevent mounting base from snapping your fingers, hold the base lighly as shown, DO NOT press against base against wall. SLOWLY slide tab STRAIGHT DOWN AGAINST THE WALL stretching strip at least 20cm until mounting bases releases from the wall.
Note: NEVER pull strip out at an angle. Strip could break or damage surface
