1 x Towel Bar
4 x Large Adhesive Strips
1 x Adhesive Cleaning Sheet
Hangs a variety of towels, bath towels and gloves
Do not exert force when removing the towels to prevent the towel bar from damage, affecting the bond between the wall and the strips
High-strength adhesive works great on a variety of surfaces – tile, fiberglass, painted surfaces, finished wood, mirrors and more
Slowly pull the tab straight down for damage-free removal from surface
One bar holds 3KG
To apply towel bar:
1. Clean & Dry Surface
Step A: Clean, wipe wall and dry.
Step B: Tear adhesive cleaning foil along the dotted line. Avoid hand contact with sheet.
Step C: Apply the adhesive cleaning sheet to the intended position of the strip in a downward direction and let it stand for 5 minutes. Make sure the wall is dry before proceeding to step 2.
*Note: Do not remove sheet from foil and avoid hand contact with cleaning sheet. Rinse with water immediately if in contact with skin.
2. Seperate & Apply strip
Two strips will go on each mounting base. Remove red Command strip liner. Align square end of strip with solid line on top of mounting base. Placing one strip on each side of the dotted liines. Remove black “wall side” liners.
3. Position & Press Firmly
Position towel bar horizontally and press the entire towel bar firmly against surface for 30 seconds.
Caution: Place towel bar in accessible position for removal by ensuring tab can stretch at least 20cm downwards upon removal
4. For optimal holding strength
Remove towel bar by sliding it upwards to remove from mounting bases. Remove gently to avoid scratching the surfaces.
5. Press firmly
Use your palm to firmly press each of the mounting bases along the length of the strip for at least 30 seconds.
Note: If mounting in moist areas, especially on ceramic tile or glass, wait 24 hours to allow adhesive to bond before use.
6. Attach towel bar
Slide towel bar back onto mounting bases, pushing it all the way down until it snaps into place.
1. Hold Towel Bar lightly as shown and slide upwards to remove Towel Bar from bases
2. Remove strip
To prevent mounting base from snapping your fingers, hold the base lighly as shown. DO NOT press against base against wall. SLOWLY slide tab STRAIGHT DOWN AGAINST THE WALL stretching strip at least 20cm until mounting bases releases from the wall.
Note: NEVER pull strip out at an angle. Strip could break or damage surface.