Watco Clear Crystal Clear Lacquer Gloss 1 Quart (946ml)
WATCO® Lacquer Clear Wood Finish is the finest brushing lacquer available. WATCO® Lacquer fills in the pores of most wood types eliminating the need for wood filler. Apply to furniture, doors, cabinets and paneling for a crystal-clear, durable wood finish. Dries in 30 minutes and does not require sanding between coats. Please read product labels for additional directions and precautions before using
- Fast-drying
- Durable protection
- Ideal for use on furniture, doors, cabinets and paneling; not recommended for floors or exterior surfaces
- Formulated for a higher clarity finish than polyurethane
- Dries to the touch in 1 hour and covers up to 290 sq ft
- Eliminates the need for wood filler and protects against scratches; no need to sand between coats
- Dries to a crystal-clear gloss with a lasting durable finish
- Apply to furniture, doors, cabinets and paneling
- Dries in 30 minutes and does not require sanding between coats
For Best Results
- Apply with good quality natural bristle brush. Use adequate ventilation at all times.
- Do not apply in direct sunlight.
- Apply only when the air and surface temperatures are between 55-90°F (13-32°C) and the relative humidity is below 85%.
- If applying over white or pastel paints or stains, test in an inconspicuous area before beginning.
- Testing is important when applying over paints or stains as an undesired appearance may occur when these products are topcoated with a lacquer finish.
- BRUSH
- Stir thoroughly before and during use. To prevent bubbles in the finish, DO NOT SHAKE, over brush, or apply with a roller.
- Apply using a good quality bristle brush or applicator. Allow the finish to dry 2 hours and then recoat. Recoat only when the previous coat has dried clear and feels hard.
- If any coat has dried more than 6 hours, lightly sand with 220 grit sandpaper before recoating to avoid brush marks.
- Apply additional coats following directions above.
- A minimum of 3 coats is recommended.
- Allow finish to dry 24 hours before light use. Allow 7 days before subjecting the surface to normal usage.